wiki/linux/dislocker.md

@@ -1,33 +0,0 @@
-# Dislocker
-
-[Dislocker](https://github.com/Aorimn/dislocker) is a driver to read and write
-Bitlocker-ed volumes under Linux systems.
-
-## Setup
-
-On most of the Linux distributions Dislocker is bundled with the `dislocker`
-package.
-
-## Mounting Bitlocker-ed volume
-
-For the mounting to work two directories are required.
-One to mount the `dislocker-file` (`/mnt/bitlocker`) and one to mount the
-windows volume (`/mnt/windows`).
-The device which holds the windows partition is assumed to be calles
-`/dev/sdc1`.
-
-The following command mounts the `dislocker` file to `/mnt/bitlocker`.
-Make sure to replace the password in the following command.
-There is no gap between the `-u` and the password:
-`sudo dislocker /dev/sdc1 -u<password> -- /mnt/bitlocker`
-
-Alternatively a recovery key can be used:
-`sudo dislocker /dev/sdc1 -p<recovery_password> -- /mnt/bitlocker`
-
-Afterwards the `dislocker-file` can be mounted to the `/mnt/windows` directory.
-`sudo mount -o loop /mnt/bitlocker/dislocker-file /mnt/windows`
-
-Following these commands the windows partition can be found mounted on
-`/mnt/windows`.
-It is possible that the partition uses the NTFS which requires the `ntfs-3g`
-package to be installed to work with linux.

wiki/linux/flatpak.md

@@ -17,8 +17,3 @@ When software installation is done with Flatpak it is recommended to pass the
 `--user` so the software is not installed system-wide but for the user only.
 In practice it looks like the following:
 `flatpak install --user <package to install>`.
-
-## Running software
-
-Software installed via flatpak can be run by typing the full package path into
-the command line, for example `com.makemkv.MakeMKV`.